APPENDIX A: EPIM INFORMATION
A-4
SEH USER’S GUIDE
Note
: The transmitter power levels given above are Peak Power Levels
after optical overshoot. You must use a Peak Power Meter to correctly
compare the values given above to those measured on any particular port.
If you are measuring power levels with an Average Power Meter, add 3
dBm to the average power measurement to correctly compare the average
power values measured to the values listed above (i.e., -33.5 dBm average
+ 3 dBm = -30.5 dBm peak).
Parameter
Typical
Minimum
Maximum
Transmitter Peak
Wave Length
1300 nm
1270 nm
1330 nm
Spectral Width
60 nm
-
100 nm
Rise Time
3.0 ns
2.7 ns
5.0 ns
Fall Time
2.5 ns
2.2 ns
5.0 ns
Duty Cycle
50.1%
49.6%
50.7%
Bit Error Rate:
Better than 10
-10
Receive
Sensitivity
dBm
Less Power
More Power
-40
-35
-30
-25
-20
-15
-10
-5
0
Maximum
Receive
Input Power
Transmitter Power*
(At 25
°
C into
8.3/125
µ
m fiber)
Minimum Sensitivity (-30.0)
Typical Sensitivity (-31.0)
Maximum Sensitivity (-36.0)
Maximum Receive Input (-6.99)
Typical Receive Input (-7.5)
Minimum Receive Input (-9.72)
Maximum Transmit Power (-12.0)
Typical Transmit Power (-15.5)
Minimum Transmit Power (-21.0)
* Transmit Power Typical Power Minimum Power Maximum Power
Coefficient
(See Note Below)-0.15dBm/
°
C -0.12 dBm/
°
C-0.18 dBm/
°
C
SEH Book Page 4 Tuesday, March 19, 1996 4:12 PM
