2-1
Chapter 2
Installing the 9C300-1
Environmental Module
Installing the 9C300-1 Environmental Module
The 9C300-1 Environmental Module is installed in the slot above the module card
cage in the front of the MMAC-Plus chassis, as shown in Figure 2-1.
Install an Environmental Module by following the steps below:
1.
Unpack the Environmental Module by removing it from the shipping box and
sliding the two foam end caps off the unit. (Save the shipping box and
packing materials in the event the Environmental Module must be
reshipped.)
2.
Remove it from the protective plastic bag. Observe all precautions to prevent
damage from Electrostatic Discharge (ESD). (Save the bag in the event the
Environmental Module must be reshipped.)
3.
Remove the plastic protective cap that covers the connector on the rear of the
Environmental Module.
4.
Examine it carefully, checking for damage. If any damage exists, DO NOT
install it. Immediately contact Cabletron Systems Technical Support.
5.
Hold the left and right sides.
6.
Line up the rails on the left and right sides with the tracks on the left and right
inside panels of the chassis.
7.
Slide the Environmental Module into the chassis until it is completely seated.
If the MMAC-Plus chassis has been powered up, the 9C300-1 Environmental
Module illuminates the STATUS and ALARM LEDs and displays the name
Cabletron on the LCD.
If the LEDs are any color other than green, refer to LANVIEW LEDs in Chapter 3.
If no keypad entries are made within 60 seconds, the LCD scrolls through various
non-interactive mode screens.
Summary of Contents for Environmental Module TM 9C300-1
Page 1: ...MMAC Plus 9C300 1 Environmental Module User s Guide...
Page 2: ......
Page 36: ...9C300 1 Environmental Module Operation 3 24...
Page 46: ...EPIM Specifications A 8...
