Workgroup Remote Access Switch 17
B
ASICS
Return Configuration to Factory Defaults
If your system was previously accessed by your distributor, the preconfigured password will
be admin (in lower case). Change this password to secure your system. To make this change,
enter the following command at the system prompt:
pswd
Then follow the prompts to enter a new password. Your password must be a 3 to 16 nonblank
character string. Be careful, passwords are uppercase and lowercase sensitive.
R
ETURN
C
ONFIGURATION
TO
F
ACTORY
D
EFAULTS
The default configuration files are located on the CSX1200 CD. If you wish to return to the default
configuration, download the
DEFLTCFG.OSW
file. Follow the same steps for Local or Remote
Upgrade except you download the file
DEFLTCFG.OSW
instead of the
UPGRADE.OSW
file.
I
NITIAL
I
NSTALLATION
S
TEPS
There are initial configuration steps you must complete (regardless of remote device connections).
We outline these steps in the following sections.
B
EGINNING
THE
C
ONFIGURATION
P
ROCESS
1.
When you power on your system, the CyberSWITCH program automatically starts. Enter your
log-in id (
admin
)
. Next, enter a password.
2.
Start up the configuration editor, CFGEDIT; at the system prompt, type:
cfgedit
Note:
If you are unsure of any configuration values, use the defaults.
Use the displayed CFGEDIT menu to complete the remaining configuration steps.
P
HYSICAL
R
ESOURCE
C
ONFIGURATION
1.
Select Physical Resources from the main menu. Then, select Resource to display your
CyberSWITCH’s resources.
2.
A display of preconfigured resources and the pertinent slot numbers and switch types for those
resources appears.
3.
Add all WAN resources. Depending on the type of WAN resource you have in your system,
select either a Basic Rate or Primary Rate resource from the displayed list of resources. If you
have selected Primary Rate, you should choose slave as the synchronization type. You will also
need to configure any expansion resources at this time if you selected Primary Rate. (Note: The
BASIC_RATE_NET resource type is a test facility. Do not select this for your resource type.)
After all resources have been added, return to the Physical Resource menu.
4.
Configure the WAN lines. Select Data Line from the Physical Resources menu. After you select
to add a line you will be prompted for the line name. Enter LINE1 for the first line name. Next,
select the line’s slot number and port number from the displayed list. The information
