Cabletron Systems 9C214-2, Installation Manual

Page: 16 / 30

Installing the 9C214-2 Power Supply
2-2
5. Remove the cover. (Keep the cover in the event you need to remove the power
supply. The cover must be replaced to protect the connector.)
6. Hold the power supply by the handles on the top and bottom of the unit, and
do the following:
a. Align the power supply so that the lip on the bottom and the hook on the
top are slightly above the corresponding slots on the chassis.
b. Ease the power supply down until the hook catches the slot on the top and
the tab is inserted in the slot on the bottom.
c. Plug the power supply into the connector on the back of the chassis by
pushing the power supply until its frame touches the surface of the
SmartSwitch 9000 chassis. Do not force the power supply in place. If
significant resistance is encountered before the frame is flush with the
chassis, remove the power supply, realign it, and push it in again.
d. Secure the power supply to the chassis by tightening the two screws on
the top and two screws on the bottom of the power supply. For proper
chassis grounding, the four screws must be properly tightened.
7. If you are installing a second power supply, repeat steps 1–6.