Page 40
Model 256/PC Instruction Manual
OPERATING INSTRUCTIONS - KEYBOARD
INTRODUCTION
The Model 256/PC can be controlled from a keyboard instead of the front panel controls.
Keyboard control can be added by interfacing to an optional CRT/Terminal or a Personal
Computer (PC) that is running Cablescan PC DOS Terminal Emulation Program, TERM. Refer
to the Preparation section for setting up a CRT/Terminal or PC. Using a keyboard, the operator
can execute most functions available through the Front Panel switches.
The CRT/Terminal or PC also allows the operator to view 24 lines of information on the monitor
instead of just the single line on the Front Panel display.
ENTERING COMMANDS
Commands are entered at the system prompt. To get the prompt, press the ESC key on the
Keyboard. All commands are two letters that are executed by pressing their two keys, followed
by an ENTER.
There are four categories of commands as shown below:
•
Test
- test-related commands that allow a single or continuous test to be run, and self
testing of the tester.
•
Build
- used to start the build or assembly related modes such as Sequential or Random
build and Search mode.
•
- used to obtain a hardcopy of test programs and test results.
•
Programs
- used to load, save, and maintain programs in memory and on the external
cartridge.
Summary of Contents for 256/PC
