5G CPE User Manual
Page 12 , Total 25
3.2.1 Basic Wireless Settings
Wireless Mode
：
used for working mode of WLAN, 5G CPE supporting AP Mode, Station Mode, AP WDS
Mode and Station WDS Mode, the default is Station Mode.
Because settings of those 4 modes have little impact to parameter setting of whole Radio,we will not
introduce parameter setting of Radio for 4 modes.
Country code
：
used for setting country code of Radio, the default is China
；
IEEE 802.11 Mode
：
used for setting working mode of Radio, the default is 802.11a
；
Channel Width
：
used for setting occupied bandwidth of channel, the default is 20MHz Mode
；
Channel
：
used for setting working channel of Radio, the default is auto channel
；
Tx Power
：
used for setting transmission power of Radio, the default is 24dBm
；
※
Attention
：
Transmission power can influence signal strength of wirelss communication. when it
transmits in long distance, pls properly increase transmit power to ensure stronger singal. And when
testing indoor, pls properly decrease transimission power in order to prevent signal saturation for
higher signal strength.
Max TX Rate
：
used for setting packets sending rate of Radio. 5G CPE is 2X2 device, so max support is
MCS=15 and default setting.
3.2.2 Advanced Wireless Settings
RTS Threshold
：
used for setting RTS/CTS threshold, the default is off state
；
※
Attention
：
RTS/CTS is mainly to prevent hidden node disturbing. But if RTS/CTS threshold is set
much smaller, it may obviously reduce throughtput rate of wireless communication.
Fragmentation Threshold
：
used for setting fragmentation threshold, the default is off state
；
Distance
：
used for setting transmission distance between AP and STA, so that system can choose proper
ACK _timeout, the default is 3Km. When it is transmitting in long distance, proper adjusting Distance can
improve throughtput rate.
Aggr Enable
：
used for setting “enable” and “to enable”sending function of A-MPDU, the default is enable
state
；
Aggr limit Enable
：
used for setting sending limit function of A-MPDU, the default is enable state, the max
aggr packet of the default is 64 units, the max aggr length is 60000 bytes. As long as one conditon meets, it
