16
Operator’s Manual
Edition 7/06
Loading Material
MACH4
6.1.3
Loading fanfold labels
The method of loading fanfold labels applies to both thermal paper labels and labels that are printed by
means of a transfer ribbon.
Fig. 5:
Loading fanfold labels
1. Stack the fan-folded labels (1) behind the printer. Ensure that the labels on the strip are facing
upwards.
2. Open the cover (3) and hinge down the control panel (5).
3. Feed the fan-folded labels (1) below the cover (3) and over the roll holder (2).
4. Adapting the roll holder (3) to the label width:
Take the roll holder (2) out of the holder slots (4) in the printer. Remove the adapter from the the roll
holder (see section 6.1.1 on page 14).
Place the roll holder back into the holder slots (4) on the printer. Ensure that the rounded surfaces
of the edge stop are facing forward.
5. Press the release button (6) and hinge the print module up.
6. Feed the fanfold labels forwards under the deflector, fig. 4 (6), and over the print roller, fig. 4 (9), until
it projects about 15 cm out of the printer.
7. Move the label guides (8) apart with the setting wheel (7) until the labels can pass between them.
Press the strip label down with the hand, and move the label guides (8) back up against the edges
of the label.
8. Hinge the print module down and press evenly on the two marked surfaces so that the unit snaps in
on both sides.
9. Feed the label stock out through the slot in the control panel (5). Hinge up the control panel (5) and
close the cover (3).
4
6
5
1
3
1
2
A
View A