21
3.2
Setting the Winding Force
8
7
6
5
1
2
3
4
Fig. 15
Setting the winding force
The settings of the winding force of the break (5) of the unwinder and the clutch (6) of the rewinder is done in the
same way.
1. Insert the ribbon retainer (4) onto the winders.
2. Fold the printhead assembly group up and undo the three screws (8) and remove the cover (7).
3. Hold the ribbon retainer, push holder (2) towards the frame (1) turning it to the desired position and let go, taking
note that the straps of the locks (3) are all the way in the provided gaps.
4. Test the winding force again and compare it to the these to the test values and correct if necessary.
5. refasten the cover (7) with three screws (8).
i
Note!
The numbers of the retainer (2) are not setting values. They are an orientation when setting the winding
force.
1: smallest winding force, 7: largest winding force
3 Adjustments
