11
5.2
Rewinding onto 40 mm (1.6 in) Cardboard Core
i
Note!
Ensure that the spring (1) is mounted on the rewind axle (2)!
Consider that the cardboard core (3) should be about 1 mm (0.04 in) broader than the label strip
!
Caution!
Risk of injury by rotating parts!
When switching on the rewinder starts immediately and winds until the material is tightened.
3
5
4
2
1
1. Put the cardboard core (3) on the rewind axle (2).
i
Note!
Consider the selected winding direction:
•
The broken line is valid for inside wound
labels.
•
The solid line is valid for outside wound labels.
2. Feed the label strip over the guide axle (8) and under the
roller (7) up to the cardboard core (3).
i
Note!
When using a rewinder of the type ERx/300
for winding labels inside, lead the label strip
additionally over the guide axle (9).
Ensure that the label strip touches the disc (6).
3.
Affix the end of the label strip with consideration of the
selected rewinding direction to the cardboard core using
adhesive tape or label.
4. Slide the plate (5) with the knurled screw outward onto
the rewind axle until it stops.
i
Note!
When using small labels it is possible that the
cardboard core does not cover the spring over
the whole length. In this case the groove on
the plate must be aligned so that it fits to the
spring of the rewind axle.
5. Tighten the knurled screw (4) on the plate.
6. Switch on the rewinder at the power switch.
7
6
2 3
8
ER4/210
9
7
6
2 3
8
ERx/300
Figure 7 Rewinding onto 40 mm cardboard core
