10
10
4.3
Alignment the Guide Axle
Depend of the used printer the guide axle should be aligned so, that the label strip is led horizontally from the printer
to the rewinder.
Figure 6 Alignment the guide axle
1. Loosen the guide axle (1) by turning it counterclockwise.
2. Move it in the guide plate (2) up to the desired positioning.
3. Fasten the guide axle (1) by turning it clockwise.
Figure 5 Direction of rewinding
Turn off the rewinder and set the switch (1) to the required direction of rewinding:
Rewinding with labels inside
Rewinding with labels outside
4.2
Selection of the Rewind Direction
The selection of the rewind direction is depend of using an inside or outside wound label.
4
Alignment
2
1
1
