18
18
6.2
Standard Operation
!
Warning!
Risk of injury by rotating parts!
During operation, rotating parts are freely accessible.
Ensure that people‘s clothing, hair, jewelry etc. do not come into contact with the exposed rotating parts.
!
Attention!
Peel-off mode must be activated in the software.
This is done with the "P command" in the direct programming.
Programming Manual cab printers
i
Note!
The labelling process can be modified by setting the following parameters
• Setup > Labelling > Tube locking
• Setup > Labelling > Tube unlocking
• Setup > Labelling > Check tube removal
!
Attention!
The following steps can be released by selecting
or sending the IO signal START.
Within one cycle only that release method will be accepted which was used for the first step.
Send a print job.
Insert the first tube.
Press
.
The tube will be pressed against the transport rollers.
Press
.
The first label will be printed and applied onto the turning
tube.
Press
.
The pressure roller will be unlocked
Remove the tube.
Press
.
The tube removal will be checked.
Insert the next tube.
Press
again to start next cycle.