CAB A8, Operator'S Manual

Page: 79 / 134

79 cab Produkttechnik GmbH & Co KG / Tharo Systems, Inc.
Fig. 11 d Printer info display 4
The fourth page of the info display contains coded informations on the
configuration of the printer and the internal test results in the format
"xxxx / y / z / R".
xxxx Result of the system test
The four-digit hexadecimal number contains (coded) hardware faults.
The figure is the same as in the printout of the self test.
For fault encoding see code table 10 in chapter 10 "Self Test".
The example, as shown in figure 11d, displays "0000" indicating that
there have been no hardware faults.
y Type of peripheral device
0 : Cutter
1 : Present sensor
2 : Applicator
3 : None fitted
4 : External print start
For example, figure 11 d : "3" - No peripheral device connected.
z Configuration setting Transfer print / Label sensor
The value of z results from adding the code numbers for selected
settings.
Transfer print
: 1 = ON
0 = OFF
Label sensor : 8 = Bottom-Reflect
4 = Gap sensor
For example, figure 11d : "5" - Transfer print ON (1) + Gap sensor (4).
R This value represents the state of modification of the hardware (PCB).
Printer Info
4: 0000 / 3 / 5 / 03
Fig. 11 e Printer info display 5
The last of the info pages shows the name of the character set as selected in
setup.
Printer Info
5: Windows 1252