CAB 6114 Series, Assembly Instructions Manual

Page: 14 / 19

14 14 5 External Start-Sensor
5.1 Connection
The start signal to apply the label can originate from an external sensor connected to the 3 pole connector (1)
connected directly to the applicator.
1
Fig. 10 Start signal connector on the applicator
Fig. 11 Examples of connections of start sensors
The start of the printing job - print first label is still initiated over the I/O interface of the printer. Circuitry and
programming of the connections is to be set as illustrated.
5.2 Signals
• The signal FSTLBL respectively DREE
()
causes the label to be printed which is then transported to the
waiting position.
• The signal START will transport and apply the label to the product.
In the application mode
"Apply - Print" the printing of the next label starts directly after application of the previous label.
In the application mode "Print - Apply" the signal START must be sent for the print.
Pin Signal Name Description Activation/active status
without applicator with applicator
1 FSTLBL
DREE
()
-
Cycle sequence = Apply-Print
Print first label
Switch on +24V between
Pin 1 and Pin 25
13 START Print start signal
Precondition: The superior control
has confirmed with the ETE signal
that the previous label has been
taken from the peel-off position.
Start of printing and
labeling +24V between Pin 13 and Pin
25

Interface description of the printer
Table3 A section of the interface description of the label printer