16
17
7
Error Messages
7.1
Error Messages of the Printer
For detailed information about printer errors (e.g. 'Paper out', 'Ribbon out', etc.)
Check the operator's manual of the
printer.
Error treatment:
Clearing the error results.
Press the
respectively
feed
to synchronize the label feed, remove the left over labels manually.
To quit the error state press
Repeat
(HERMES Q) respectively the
pause
key (
)
.
After error correction, the label causing the error will be reprinted.
7.2
Error messages of the Air-Jet Box
The following table contains an overview of error messages and their possible causes. It also suggests methods to
resolve the problem:
Error Message
Possible Cause
Air pressure error
Air pressure ins.
()
Compressed air is switched off
Pressure to low < 4 bar
Pressure to high > 6 bar
Table4
Error messages of the Air-Jet Box
Error treatment:
Clear the error state.
In order to clear the error state press
continue, repeat
or
cancel.
Continue
with the next label in the printing queue.
Repeat
respectively the
pause
and enter key repeat the print of the label causing the error.
Only applicable with error
Vac. plate empty.
Cancel
the current print job.
!
Warning!
After the error has been resolved the pad will immediately move back to the starting position!
Danger of injury to hands and fingers by the moving pad!
Do not reach into the area of the moving pad and keep long hair, loose clothes, and jewelry away.
Reprinting a label, interrupted by an error, is not possible without a new printing job.
In the mode "apply/print" before the standard cyclic operation can commence the signal "print first label" must be
sent or push
respectively the enter key to send a printed label to the pad.
