![background image](http://html1.mh-extra.com/html/cab/5326c/5326c_assembly-instructions-manual_3223660011.webp)
11
Waiting position of the label
3
2
1
4
Fig. 6
Label transport/Reflex sensor
In the setup menu the setting "Blow on" must be selected in order to change the parameter "
Blow time"
.
After reaching the reflex sensor (1) and detection point (3) the transportation device will continue for a set time to
ensure the label (2) is transported to the pinch roller (4). This time as well as well as the position of the label can be
determined by the parameter:
> Blow time
A higher value causes a longer transport time.
200 ms accord ca. 10 mm
Follow-up Transportation
Once the label (2) leaves the sensor area the transportation module continues for a set time to ensure that the label
reaches the pinch roller and thus the product. This time value is adjustable via the parameter:
> > Support del. on
4.3
Signals
•
With the signal
DREE
will print the label and move it to the pinch roller.
•
The signal
START
will transport the label up till the reflex sensor as well as its application transport to the pinch
roller.
In the application-mode
"Apply - Print"
the printing of the next label will commence automatically as the soon as
the previous label has been applied.
In the application-mode
"Print - Apply"
the printing of a next label will wait for the the DREE signal.
Pin
Signal
Name
Description
Activation/Active State
without applicator
with applicator
1
DREE
-
Print first label
in mode "Apply-Print"
Switch on +24V between
Pin 1 and Pin 25
13
START
Print signal Prerequisite:
The primary control has
confirmed with the ETE
signal that the previous la-
bel has passed the peel-off
position.
Start of label print/applica-
tion
+24V between Pin 13 and Pin 25
Table 2
Pin assignment of the I/O interface
Interface description of the label printer Hermes C