10
10
4
Adjustments
i
Note!
The alignment of the applicator to the printer is set to the factory standard and should not be altered to
ensure reliable label transportation. Only the Angle to the printer as well as the pinch roller should be
adjusted.
4.1
Setting the Angle to the Printer
1
max 30°
Fig. 5
Downward angle of the applicator to the printer
!
Warning!
Be aware when you loosen the screws (1)! The device will drop due to its own weigh.
Loosen screws (1) to adjust the angle and so the distance between printer and pinch roller.
Place a product and adjust the angle of the device. Tighten screws (1) .
4.2
Settings within the Setup of the Printer
The configuration parameters of the applicator can be found in the menu
Setup > Machine param.
Speed
i
Note!
The speed of the belt and the label transport speed can be set via the parameter
Support del. off
.
The value is displayed in ms and not, the actual value used, mm/s.
i
Note!
It's necessary to set the exact the values visible in the table.
In case of a deviations the standard value of 100 will be used.
Parameter to set the speed of the belts.
The four available values are:
100 ms : 100 mm/s speed of the transport belt
150 ms : 150 mm/s speed of the transport belt
220 ms : 220 mm/s speed of the transport belt
300 ms : 300 mm/s speed of the transport belt
500 ms : 500 mm/s speed of the transport belt
> > Support del. off
