20
20
9.1
Test Mode without Print Job
!
Warning!
In operation of the applicator movable parts are accessible. It is particularly in the area of belt and fans.
Do not reach into the zone of the moving parts and keep long hair, loose clothes, and jewelry distant.
2
1
Fig.9
Test mode via Enter key
i
Notice!
Please use that test mode to adjust the parameter "Peel position" in the printer configuration.
The whole labelling process can be simulated without the need of a print job or a connection to a computer by alter-
nately pressing the
feed
(2) key and the Enter key (1) :
Press the
feed
key (2).
A blank label is fed. The vacuum from the fans as well as the supporting air (blow tube) are switched on. After the
detecting the label from reflex sensor, the supporting air is switched off.
Press the Enter key (1).
The label will moved to the labelling position.
9.2
Test Mode with Print Job
i
Notice!
Please use that test mode to adjust the peel-off offset in the software.
That method allows to check labelling process with the real print data using the Enter key (1).
Send a print job.
The test mode is executed in two half cycles :
Press the Enter key (1).
Half cycle 1
A label is printed. The vacuum from the fans as well as the supporting air (blow tube) are switched on. After the
label has been picked up by the applicator, the supporting air is switched off.
Press the Enter key (1) again.
Half cycle 2
The label will moved to the labelling position.
If the label is manually removed after the first half cycle, the half cycle 1 will be repeated when the pre-dispense key
is pressed again.
9
Operation