16
16
7
Adjustments
i
Notice!
The right position of the applicator to the printer is adjusted ex factory and is not to change.
Adjust only the Degree of the applicator to the printer and the pressure of the pressure roll.
7.1
Adjust the angle to the printer
2
1
max 45°
A
5214 ...-2 A= 105 mm
531x ...-3 A= 155 mm
Fig.6
Angle to printer
!
Warning!
Attention if you lose the screws (1 und 2)! Device dump down.
Lose both screws (1 and 2) to adjust the angle and so in follow the depth of the applicator to the printer.
Adjust angle or the depth on a product and tighten screws (1 and 2).
7.2
Adjust the pressure roll
2
1
Fig.7
Pressure
With the setting screw (1) it is possible to change the pressure which the label apply on the product.
Adjust the pressure so that the label apply bubble-free over the full area.
Do not damage the product with to much pressure
Setting screw (2) adjust the lower position of the roll in fine adjustment.
