12
12
4
Error Messages
4.1
Error Messages of the Printer
For detailed information about printer errors (e.g. 'Paper out', 'Ribbon out', etc.)
Check the operator's manual of the
printer.
Error treatment:
Clearing the error results.
Press the
feed
key to synchronize the label feed, remove the left over labels manually.
Press the
pause
key to quit the error state.
After error correction, the label causing the error will be reprinted.
4.2
Error Messages of the Applicator
The following table contains an overview of applicator specific error messages and their possible causes. It also
suggests methods to resolve the problems:
Error Message
Possible Cause
Air pressure ins.
Compressed air is switched off
Pressure to low < 4 bar
Pressure to high > 6 bar
Label not depos.
Label has not been placed onto the product; after the pad has moved back the label is
still sticking to the pad.
Lower position
Pad has not reached the starting position within 2s after the pad has left the labelling
position; or pad has left the starting position without authorization.
Process Error
Process of labeling was interrupted via the I/O interface of the printer with the XSTP
signal.
Refl. sensor blk.
There has been no change of the switch state at the upper sensor at the cylinder
between the start of the labelling process and the signal from the labelling position
sensor.
Upper position
Pad is not in the starting position when the printer is switched on.
Pad has not reached the labelling position within 2s after the movement of the pad was
started.
Pad has left the printing position without authorization.
Vac. plate empty
Label has not been picked up properly by the pad; or label fell off the pad before it could
be placed onto the product.
Table 2
Error messages of the applicator
Error treatment:
Clear the error results.
Press the
pause
key to quit the error state.
i
Note!
In the case of errors check the
Service Manual for adjustment and settings.
!
Warning!
After the error has been resolved the pad will immediately move back to the starting position!
Danger of crushing hands and fingers by the moving pad!
Do not reach into the zone of the moving pad and keep long hair, loose clothes, and jewelry distant.
After error correction, the printing of the label causing the error cannot be repeated without restarting the print job
except the error "
Vac. plate empty"
.
In this case, the last label will be printed again after resolution via the
pause
key and then pressing the Enter button .
In the application mode "Apply/Print" sends the signal "Print first label" or press the button
to send a printed
label to the tamp.
