CA CAD-AIRX300, User Manual, Page: 7 / 23

Solutions Problems
Slow inflation
1. The battery power may be low. Charge your inflator.
2. The air hose is leaking or not properly connected.
Tighten the air hose to your inflatables and the flator.
3. The inflatable is leaking. Repair or replace it.
1. The battery may be low. Charge your inflator.
2. The current pressure is higher than the set pressure.
Reset the target pressure value.
Inflatables like balloons have a very low pressure,
which cannot be measured by the inflator.
Cannot inflate
Inflating, but the
pressure reads zero
5
Troubleshooting
After connecting
the air pose, the
power turns off.
Press and hold the Power button to turn it
on again.
When air leakage occurs during inflation, the inflator
will stop working. This icon will appear on the screen,
and the inflator will make a sound. Check if the air hose
or inflated item is leaking. When air leakage is solved,
press the Power button to start the inflator up again.
When temperature during inflation is too high, the
inflator will stop working. This icon will appear on the
screen, and the inflator will make a sound. Wait until
the inflator cools down and the icon disappears. Then
press the Power button toto start the inflator up again.
The battery power is low, charge your inflator first.
EN 6