※
Please insert and confirm that the brake cables go through
the locking screw of the brake plate and lock the brake line
cables. If they are not tightly locked, it may cause brake
system failure or the scooter to operate abnormally.
※
The other end of the brake cable should be connected to the head
brake handle. If the end wiring is in normal condition, the head
brake handle may be abnormally connected.
※
In case the electromagnetic brake abnormality has nothing to do
with the brake plate / brake cable and the electromagnetic brake
needs to be repaired, please refer to the electromagnetic brake
repair section.
※
In case of brake failure, check whether the brake cable and the
adjustment line are normal. The brake plate may be damaged or
worn out. Please replace with a new brake plate.
38
8-4 Left/right brake adjustment :
※
Hex wrench #10 x 1pcs
1.Refer to 3-1 Powering off the battery to power off the scooter.
2.Refer to 8-3 Rear wheel maintenance to remove the rear wheel.
3.Loosen the right brake plate adjustment screw.
※
It is the same for the left/right brake cables.
8-5 Left/right brake plate maintenance :
※
Hex wrench #10 x 1pcs
※
Cross tool x 1pcs
1.Refer to 3-1 Powering off the battery to
power off the scooter.
2.Please refer to 8-4 Left / right brake
adjustment : invalid.
3.Loosen the right brake adjustment screw.
4.Remove the right brake cable and spring.
5.Remove the brake plate locking screw
(M6 x12L x 1pcs).
6.The brake plate set can be removed.
※
The left/right brake plate can be disassembled in the same way.
※
Please follow the above steps in reverse for reassembly and replacement.
8-6 Brake handle maintenance :
※
Cross tool x 1pcs
※
Hex wrench #8 x 1pcs
1.Refer to 3-1 Powering off the battery to power off the scooter.
2.Remove the fixing screw set (MS x20L x 1pcs).
3.Remove the brake cable.
4.The brake handle can now be removed.
2.
3.
3.
4.
5.
300+-30kgf-cm
30kgf-cm
4.
6.
