Support Services:
Training/Servicing/Repairs
Training
- This manual is comprehensive but cannot
replace tuition. Excellent training is available directly
from C.Scope and via authorised C.Scope agents, cost
effectively, at your chosen location. We always
recommend that operators are trained before using
C.Scope Pipe and Cable Locators.
Calibration
- These C.Scope Locators and Signal
Generators/ Transmitters do not require periodic
re-calibration. However, where validation and
certification is a requirement this is available from
C.Scope and C.Scope Authorised Service Centres.
Servicing
- Routine Servicing of your equipment
is available from C.Scope and C.Scope Authorised
Service Centres if required.
Repairs
- Before returning equipment suspected of being
faulty, please check the machine carefully with a fresh set
of batteries. Check the battery connections and rotate the
batteries in the holder. Refer to the section in the manual
on Function Checks and if possible substitute known good
equipment as a confirmation.
If the problem persists then contact the company from
whom you purchased the equipment, OR contact C.Scope
stating the serial number, date and place of purchase and
indicating briefly the nature of the fault. Advice on the best
course of action can then be given.
59
Copyright © 2013 C.Scope International Ltd. All Rights Reserved.
C.Scope International Ltd make every effort to ensure that the information we provide about our products and their use is correct. We do not accept responsibility for
injury, damage, or consequential loss arising from the use of our products. Local, national and international requirements and regulations must take preference.
