C. Davis Systems
CDS-LC
3.0
INSTALLATION
3.1
Set-Up
3.1.1 Place the machine on a solid table or work bench. Soft
tables’ can dampen the vibratory feeders.
3.1.2 The Contact Feeder Crimper requires one 110-120 VAC
power source and an air supply with a range of 100-120 PSI.
Hoses should be a minimum of 1/4" ID with 1/4" fittings.
3.1.3 Set all sensors according to the sensor adjustments in
section 6.3.
3.1.4 Set the gap between the Slide Escapements and the feeder
bowls. The gap should not be big enough for the contact to
fall into.
On Vertical Escapements, the Orienter unit should be lined
up with the Escapement below.
3.1.5 Connect feed tube line into upper hole of reject “y” on the
back of the crimp head. Connect tank and tube to lower hole
reject “y”. Note: Reject tank will need to be emptied
periodically as jamming will result.
Model #CDS-LC C. Davis Systems Inc. Operations Manual
