Wiser Home Controller Installation Instructions
24
If you have previously configured a broadband router, the Wiser Home
Controller configuration procedure is very similar. During the configuration
session, you will set up the following:
•
Change password on Administration page (recommended)
•
Host Name and Domain Name on Setup page (optional)
•
Wireless Settings on Wireless page and Wireless Security page
•
Remote access on Administration page or User UI
Changing the password is recommended for security reasons. You can
change the password, but you cannot change the username. Passwords are
limited to 30 characters. Do NOT use spaces or any of the following in your
router password:
' " \ < >
&
Setup Page Window
Follow the steps below during your configuration session.
1. The first display you see is the Setup page window. Add a Host
Name and Domain Name if needed and then move to other pages.
After you make changes on a page and select Save Settings the
router reboots and the new information is captured for future
sessions. Allow about 90 seconds for a reboot.
The following message appears to notify the system is rebooting (a
reboot could take about 90 seconds):
Your changes have been saved.
System Rebooting…Please wait…
2. Go to the Administration tab and change the password. This is
highly recommended for security reasons. Save settings.
3. Select the Wireless tab and set up the wireless parameters.
Wireless Page Window
In the Setup window, click Wireless to view the options for the Wiser Home
Controller's wireless LAN. Clipsal highly recommends setting up security at
this time to stop intruders. Refer to Section 2.3 Setting up a Wireless LAN.
