If your new code is allowed an accept tone will be given. If the new code is
barred an error tone will be given and your old code will still be valid. Start
again and enter a different four digit code.
To remove or disable a second user code enter the four digit user code, the
buzzer will emit a steady sound and the exit time start. Press the * key
followed by the 9 key, followed by the 2 key. The LEDs 1 2 3 and 4 will now
come on to indicate a new 4 digit code is required. Enter 0-0-0-0 (four zero
keys). As you press each key one LED will go out. After the last key an accept
tone will be given and the second user code will be disabled.
4.4 REVIEWING THE ALARM LOGS
Enter the four digit user code, the buzzer will emit a steady sound and the exit
time start. Press the * key followed by the 9 key, then press the 3 key. The log
routine will start viewing 'DAY' 1 'SET'
The log is organised as 'SET' and 'UNSET' events. All events are recorded.
The first alarm is shown by the relevant LED being lit continuously.
Subsequent alarms are shown by a fast pulse of the zone LED. Any zones
isolated are shown by a slow pulse of the zone LED. The buzzer will sound
whilst viewing the 'SET' logs but will be silent whilst viewing the 'UNSET' logs.
Pressing the "0" key while reviewing the logs will show the last event to occur
even the panel has been set numerous times since.
Pressing the # key will change between viewing the 'SET' and 'UNSET' logs.
This may be done at any time. The log review will automatically end after 15
seconds
if no keys are pressed.
Press the * key to finish.
http://groups.msn.com/UKSecurityPanels
4.5 WALK TEST
( Should be performed at least once a month )
You should test your system at regular intervals, to aid this, a walk test mode
is provided. You are allowed to test all ALARM devices.
DO NOT TEST ANY
PERSONAL ATTACK BUTTONS.
Enter the four digit user code, the buzzer will emit a steady sound and the exit
Technical Manuals Online! - http://www.tech-man.com
