21
MCU Version
: Display MCU version information
Camera Version:
Display camera version information
AF Version:
Display the focus version information
Lens:
Display the lens zoom
3.3.6 Restore Default
Move the pointer to the (RESTORE DEFAULT) in the Main Menu, click the
【
HOME
】
and enter the (RESTORE DEFAULT) as follow,
Restore default:
options: yes/no; after restoring default, the video format will not be restored.
Note: If the address of former remoter is not 1 but another one from 2,3,4, the corresponding camera address will restore to 1
when all parameters or system parameters are restored. User should change the remoter address to be 1 (press No.1 according to
the camera so to get normal operation )
4.Serial Communication Control
Under common working conditions the camera can be controlled through RS232/RS485 interface (VISCA), RS232C
serial parameter are as follows:
Baud rate: 2400/4800/9600/115200 bits / sec; Start bit: 1; data bits: 8; Stop bit: 1; Parity: None.
After powering on, the camera will perform a self-test. Self-test is finished after the zoom moves to the farthest and then back to the
nearest position. If the camera has a “0” preset stored it will return to that position after initialization. At this point,
the user can
control the camera by the serial commands.
RESTORE DEFAULT
＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝
Restore Default? NO
[
↑↓
]Select
[
←
→
]Change
Value
[Menu]Back
[Home]OK
VERSION
＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝＝
MCU Version 3.1.0 2019-09-26
Camera Version 1.0.5 2019-09-27
AF Version 1.0.0 2019-09-07
[
↑↓
]Select
[
←
→
]Change Value
[Menu]Back
[Home]OK
