BYD ECB70, Operator'S Manual

Page: 16 / 23

ECB70 / 80
31
OM-ECB70 / 802019001-EN
OPERATOR MANUAL
30
OM-ECB70 / 802019001-EN
Storage and Restoring
Procedures of Storage
Clean and remove the dust on the forklift components and conduct the following procedures:
1.Check forklift for oil and water leakage and abnormal components. If yes, repair the forklift
first.
2.Fully lift and lower the forks several times.
3.Lower the forks.
4.Spray a layer of lubricant over the parts left unpainted.
5.Check the hydraulic oil level and add if necessary.
6.Lubricate all the components.
7.Take off the key and make sure that forklift is disconnected from the battery power and press
down the emergency disconnect switch. Battery status of charge should be around 50% to avoid
over-discharge or full charge for long-term storage.
8.Use and operate the forklift for a while every month.
Procedures of Restoring
Clean and remove the dust on the forklift components and conduct the following procedures:
1.Lubricate all the components.
2.Fully lift and lower the forks and tilt masts several times.
3.Check the status of charge of the traction battery.
4.Check the hydraulic oil. Replace it if necessary.
Caution
The operator should repeatedly check the performance of the forklift brake when operating it
for the first time after the forklift has been restored to service.
MAINTENANCE
This chapter explains how to maintain the forklift.
Daily Maintenance
Period and Items
Daily (or every 8 hours) and weekly (or every 40 hours) for daily inspection items, whichever
comes first. If the forklift works less than 8 hours per day, conduct the inspection and checks on a
daily basis. if daily working hours exceed 8 hours, conduct the inspection and checks every 8 hours.
Inspection checklist:
No. Item 1 day 1 week
8 hours 40 hours
1 Exterior Check
2 Wheel Clean and tighten Clean and tighten
3 Mast Check
4 Hydraulic System Check
5 Display Check
6 Warning Equipment Check
7 Brake Check Check
8 Travel, Steering and Control Check
9 Electric Connector and Fuse Check
10 Clean Clean
11 Others Check
Caution
These inspections should be conducted before operating the forklift.
Note
Before conducting the daily inspection, recheck for any fault and error found
earlier.
Content Description
1.Exterior
(1)Check the forklift body for damage and deformation.
(2)Check the floor where the forklift is parked for oil leakage.
(3)Check the condition of the nameplate and decals.
(4)Check if any parts loose or fall off.
Note
If oil leakage occurs, confirm the location of the oil leakage and contact the BYD after sales
service.