4
2. Installation
Powermag must be installed by a professional installer
The device should be installed directly in-line on pipework in any of the
following materials; stainless steel, galvanized steel, copper or plastic.
To ensure that the device is adequately supported and does not place
excessive strain on the existing pipework, we recommend using
additional support brackets (not supplied) on the inlet and outlet
pipework. The device can be installed in either vertical or horizontal
orientation to suit your existing pipework and while it may be necessary
to install additional pipework, elbows and fittings in order to adequately
locate the device we recommend keeping this to a minimum.
The device is manufactured from stainless steel tubing and as such is
resistant to corrosion.
We recommend the use of isolation valves before and after the device to
facilitate any service or maintenance work that may be required.
The Powermag control panel should be connected to a suitable 13A
fused switched spur. Please refer to the product specification data to
ensure you have a suitable spur available.
The spur must incorporate an accessible isolation switch to enable
maintenance or repair of the device.
Under no circumstances should the Powermag coil assembly be
connected directly to any mains power supply. Always connect the coil
assembly to the control panel supplied with the device.
