54
EN
10 Warranty
If the product malfunctions during the warranty
period, please contact your contract partner, the
installation company, and specify the device type
and production number; see the device type plate
Non-compliance with the installation conditions
and the operator responsibilities leads to the loss
of warranty and exclusion of liability.
The wearing parts defined in the “Operator respon
-
sibilities” section and the consequences of failing
to replace these parts on time are not covered by
the two-year legal warranty.
BWT assumes no liability in the event that the unit
fails or if the capacity becomes deficient due to
incorrect material selection/combination, floating
corrosion products or iron and manganese deposits,
or any resulting damage thereof.
The use of regenerative that does not comply with
DIN EN 973 type A voids the warranty.
11 Troubleshooting
Fault
Cause
Remedy
Unit not supplying softened
water.
No regenerative in the regener-
ative container
Refill regenerative. Wait
3 hours for the brine to form
and start manual regeneration.
Power supply interrupted.
Restore the power supply,
check the settings and restore
them if necessary.
Unit does not supply softened
water or the flow level is too
low.
Inlet pressure is too low.
Increase inlet pressure (set
pressure reducer if necessary)
and start manual regeneration;
.
Coloured rinsing water at
start-up.
Abrasion particles in the flush
-
ing water
Repeat start-up rinse; see
.
If the fault cannot be remedied by following these instructions, please contact our after-sales service
department and quote the series and production number (see type plate on rear of product).
Summary of Contents for 6-501303
Page 28: ...28 DE H B A T...
Page 56: ...56 EN H W A D...
