17
Troubleshooting
Monitor Displays Blue Screen & Displays "No Signal"
• Do a hard reset, unplug all cables and power cables,
leave out for 1 minute, and then re-connect.
• Check to ensure that the connection to the camera is tight.
• Verify camera cable is plugged into camera port
• Verify that the trigger on power harness is put to power
+12VDC.
• If the problem still persists, verify that alternate ports
work. If alternate ports do not work, remove trigger wire
from +12VDC and select alternate channels.
Monitor Will Not Power-Up (no backlight on power)
• Check fuse
• Check +12VDC connection
• Check ground connection
• Try power and ground direct to battery
No Image On Screen
• Verify camera is on correct camera input
• Verify cable is connected to monitor
• Verify camera is connected to cable
• Connect known working camera and cable to monitor.
• Verify trigger source is supplying power
Audio on Camera
• Verify chosen camera has audio
• Verify volume setting
• Confirm that the CH3 trigger is connected to +12VDC
Summary of Contents for 8883000
Page 16: ...16 Positioning...
