4 Operating the E-Bike Charger
4.2 Manual charging mode
(Operation mode 2)
❶
EN
❶
2
%
D+
E-B IKE CHARGER
ON
OFF
To proceed automated charging of the
E-bike batteries the basic settings must be
carried out first!
i
❶
Preparations:
1.
Connect the E-Bike battery to the power
supply unit.
2.
Connect the power supply unit or up
to 2 unis to the referenced E-bike
charging socket(s) up to max. 600 W
(usually in the rear garage).
3.
By pressing the button
❶
for 3 s the
manual charging mode is activated
while driving
–
operation mode 2.
For control, the number
“2”
must be
shown in the lower left corner of the dis-
play
❶
!
i
Start of charging:
If the capacity of the board battery is suffi-
cient for operating mode 2, a small arrow
will appear in the display
❶
above the
%
-
symbol.
This activates the switching output of the
measuring shunt and switches the inver-
ter on. As a control, in the display
❶
“On”
If no arrow is displayed above the
%
- symbol,
the board battery must be recharged first
until sufficient remaining capacity is ensu-
red again.
The display
❶
then shows the
“blinking”
i
“On”
and no
symbol.
5 hours after activating operation mode 2,
this charging mode is automatically deacti-
vated.
and
will be shown.
i
For control, no number will be shown in
the left corner of the display
❶
!
BÜTTNER ELEKTRONIK
–
HYMER E-Bike Charger
34