Chapter 2
Installation and Setup
Page 2-4
Figure 2-3:
Power Take-Off Unit installed (Covers not shown)
2.2 Integration with a BK76IB
In order to install a BK703 to a BK76IB, the following instructions should be followed
(reference drawings in Appendix A):
1. First attach the two plastic caps onto the rails of the inline base. Then, attach the
two mounting brackets (9102737 and 9102738) over the two plastic caps.
2. Route the 80” vacuum tubing into the base and attach it to the tee (
Attach the 4” long vacuum tubing to the blower and the tee. The tubing from the
Inline tabletop should go into the remaining tee opening. This tee assembly should
then be placed inside the base cabinet.
3. Drop the BK703-76IB’s shoulder bolts (9102787) into the mounting brackets of
the base assembly and secure it.
4. First pull the timing belt (120352) over the two pulleys (116213). Ensure that the
pulleys are facing in the proper directions as shown in the reference drawings.
Then place the two pulleys on the shafts of the inline base and the extension table
at the same time. Secure it with the woodruff key (430250). Now pull the timing
belt over the two pulleys.
Buskro Ltd.
BK703 Vacuum Extension Table
