19
To Install: Place plug in drain hole and fold handle over. This compresses the plug
between the top and bottom plates and causes the plug to expand. You should not be able
to pull the plug out of the hole easily with the handle folded over.
To Adjust: If the drain leaks, adjust as follows; with lever folded so that it points
upward, hold the rubber body and metal plate at the bottom of the drain. Tighten handle
by turning clockwise, like a bolt 1/8 to ¼ of a turn at a time. If the handle cannot be
folded down, the handle needs to be loosened by turning counterclockwise 1/8 to ¼ turn
at a time.
9. GARMENT BAG (TURBO+2, QUANTUM, and QUANTUM “GL”) LID BAG
(ROADSTAR)
TURBO+2, QUANTUM, and QUANTUM “GL” GARMENT BAG
The garment bag is secured to the steel lid frame via snaps on the garment bag around its
perimeter. All of the snaps except for the top center snap on the garment bag are standard
snaps. The top center snap is a locking snap, identified by the writing “PUL THE DOT”
on the face. The locking snap is installed bottom first and removed top first.
ROADSTAR LID BAG
The Roadstar Lid Bag is secured to the steel lid frame via snaps on the lid bag around its
perimeter. All of these snaps are standard snaps.
10. REMOVAL AND INSTALLATION OF STONE PROTECTOR BRA
TURBO+2 AND ROADSTAR
These models each have 2 locking snaps, one on each side of the bra. The locking snap is
identified by the writing “PULL THE DOT” on the face of each locking snap stud. On
the Turbo+2 and Roadstar with Standard fenders, the locking snap is removed bottom
first and installed top first. On the Roadstar with the GT fenders, the locking snap is
removed front first and installed rear first. The locking snap goes on and comes off over
the snap stud at an angle.
The stone protector bra fits tightly on all models and is made more pliable by warming
the bra prior to installation. This can be accomplished by laying the bra in the sun.
CAUTION:
The stone protector bra should be removed when washing the trailer
regularly to remove debris and grit from between the paint and vinyl. Failure to do so
may result in abrasion and damage to the painted finish.