8
ASSEMBLY PROCEDURES
When Blowing (continued)
Fitting The Handle
3.
Rotate the nozzle tube clockwise locking it into place. (See Fig. 4)
4.
Remove the tube locking screw. (See Fig. 5)
5.
Push the assembled blower tube over the discharge port and locking pin.
6.
Rotate the tube clockwise to lock it into position. (See Fig. 6).
7.
Retighten the locking screw.
When Vacuuming
1. Using a small screwdriver, place into locking tab to unlock and open front cover inlet grill. (See Fig. 7).
2. Rotate the two vacuum tubes together then open grill and attach onto machine. Rotate tube anti-clockwise into locking
position (See Fig. 8).
3. Open zupper and pass narrow end of exhale tube through hole at opposite end. Pull narrow end of tube out of hole until
it is held firmly in place at wider end. (See Fig. 9).
4. Attach exhale tube to the machine and twist in place then tighten the securing screw. (See Fig. 10)
11
3. Rotate the nozzle tube clockwise locking it into place.
4.
Remove the tube locking screw.
5. Push the assembled blower tube over the discharge port and locking
pin.
6. Rotate the tube clockwise to lock it into position.
7. Retighten the locking screw.
When Inhaling
1. Unscrew locking wing-nut and store
safely until closing the inlet grill
2. Rotate the two inhale tubes together
then open grill and attach onto
machine.Rotate tube clockwise into
locking position.
3.Open zupper and pass narrow end of
exhale tube through hole at opposite end.
Pull narrow end of tube out of hole until
it is held firmly in place at wider end.
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10