![background image](http://html.mh-extra.com/html/bushranger/aht261/aht261_owners-operators-manual_2835614012.webp)
_
11
_
Fuel Filter
Maintenance Interval
The fuel filter should be replaced after every 100 hours of
operation.
Fuel Filter Replacement
The fuel filter is attached to the end of the fuel pick-up hose inside
the tank. To replace the fuel filter:
1. Make sure the fuel tank is empty.
2. Loosen the fuel tank cap, and pull up and remove the cap
holder.
3. Using a wire hook, gently pull the fuel filter out through the fuel
filler opening.
4. Grasp the fuel hose next to the fuel filter fitting and remove the
filter, but do not release the hose.
5. While still holding on to fuel hose, attach the new fuel filter.
6. Drop the new fuel filter back into the fuel tank.
7. Make sure that the fuel filter is not stuck in a corner of the tank, and
that the fuel hose is not doubled over
(
kinked
)
before refueling.
Fuel Pick-up Hose
Wire
Fuel Filter
Cylinder Cooling Fins
Maintenance Interval
・
The cylinder cooling fins should be cleaned after every 25 hours of operation, or one a week, or once a
week, whichever comes first.
・
Air must flow freely around and through the cylinder cooling fins to prevent engine overheating.
Leaves, grass, dirt and debris build-up on the fins will increase the operating temperature of the engine,
which can reduce engine performance and shorten engine life.
Cooling Fin Cleaning
1. Loosen the knob and remove the filter cover.
2. Twist the high tension lead boot on the spark plug
back and forth a couple of times to loosen the boot,
then pull the boot off of the spark plug.
3. Loosen the knob and lift off the cylinder cover.
4. Clean all dirt and debris from the cooling fins and
from around the cylinder base.
5. After cleaning, reinstall the cylinder cover, high ten-
sion lead boot and the filter cover.
Cap Holder
Fuel Tank
Fuel Tank Cap
Cylinder Cover
Cooling
Fins
Filter Cover
High Tension
Lead Boot
Knob
Knob