bushrangerpe.com.au
20
TO REPLACE BLADE
1. Position the blade adapter on the motor spindle.
2. Be sure the trailing edge of blade (opposite sharp edge) is up toward the motor.
3. Install the blade nut with the spring washer onto blade adapter and motor spindle.
4. Use block of wood between blade and mowing deck and then tighten the blade nut, turning clockwise.
TO SHARPEN BLADE
NOTE:
We do not recommend sharpening blade by users for safety reasons, please contact local Bushranger dealer for
replacing new blades.
Rear Maintenance
Before accessing to rear of the unit make sure that the mower is OFF
•
Turn unit OFF and remove key from control panel.
•
To access the rear for storage or maintenance to tilt the seat plate forward and access the rear
•
Unscrew the lock nut with attached wrench to unlock the rear case, and then tilt the case backward to access the
rear wiring and storage (Fig 15.1) .
•
When you are finished, carefully close the rear case and lock it back into place (Fig 15.2)
NOTE: Make sure that there are no open circuits or loose wiring BEFORE closing the rear case.
•
Carefully turn and lower the seat back to its original positio.
Fig 15.1
Fig 15.2
Lock Nut
Rear case
Controlling
unit
Safety switch
Battery
Battery Care and Maintenance
Power System: 72v 18Ah (batteries in Series)
Charge Time: approximately 8 to 10 hours. (overnight during off peak hours is suggested)
Charging and using temperature: 0 - 40 degrees Celsius.
For Best Results:
Custom designed Lithium batteries are included with your electric Mower. In order to achieve the best results , we suggest
you drain the batteries as low as possible before each charge. This may mean you are cutting more than one time between
charges. Once you have depleted a substantial amount of power from the batteries (when green indicating light of mower
flashes in green), we suggest you connect to the charger immediately. To avoid damaging the batteries, DO NOT allow
highly depleted batteries to be stored without a charge. Your battery will achieve the greatest power holding capacity after
you have charged and depleted them for a number of cycles.
Safety Precautions:
•
Never use these batteries for any other purpose than for use in your electric mower.
•
DO NOT allow your batteries to freeze. Take precautions to prevent freezing.
•
Never store your batteries when power is depleted. Ensure your batteries are charged before storing.
•
Never permit your batteries to remain without a charge for a period of longer than 60 days. Batteries MUST be charged
at least once within a 60 day period to ensure best results.
•
Do NOT leave your charger connected to the unit. Batteries need to have some power drainage and power loss to
permit best charging. Only connect the charger to the unit to charge the battery and disconnect the battery charger
when charging work is complete.