BushCADDY LSA Pilot Operating Handbook
Rev.03 5 March, 2008
Page 39 of 52
7.6 Tire
Inflation
1.
For maximum service from the tires, keep them inflated to the proper pressure 24 psi for the
main tires and 45 psi for the tail wheel and 25-30 psi for nose wheel.
2.
When checking tire pressure, examine the tires for wear, cuts, bruises and slippage. (Tire
changing position on the rim relative to the tube which is held in place by filler.)
7.7 Battery
Service
1.
The sealed 12-volt battery is located on mid firewall right side.
2.
If the battery is not up to charge, recharge initially at 4 amps, reducing to 2 amps. Fast
charging is not recommended.
3.
If charging from an external battery charger, disconnect ground lead from battery.
7.8 Brakes
1.
Aircraft is equipped with Hydraulic Disk brakes
2.
Brake Fluid, type as per manufacturer’s instructions or MIL-H-5606
3.
The brake fluid level may be checked by unscrewing filler cap on master cylinders. Check
for leaks kinked brake lines, uneven wear on pads. Note the M66 brake lining has a visible wear
notch located at the end of the lining that would tell user when the pad is at minimum material
condition.
7.9 Shock
Cords
1. Exhaust gases and oil can shorten the life of the shock cords.
2. They can be washed occasionally using mild detergent, rinse thoroughly with clear water.
Do not use solvents of any kind.
4.
Foreign objects can damage the outer shell and leave rubber unprotected. If excessive breakage
is noted, change shock cords.
5.
If shock cords no longer hold undercarriage tightly against stopper blocks, change.
7.10 Cleaning
7.10.1 Exterior Surfaces
To maintain the performance and durability of your aircraft, it is important to keep the interior and
exterior clean at all times. All traces of oil, gas and dirt should be removed. Accumulations over
time may cause fire and or corrosion. The aircraft should be washed with a mild soap and water.
Harsh abrasives or alkaline soaps or detergents could make scratches on painted or plastic surfaces,
or could cause corrosion of metal. Cover areas where cleaning solution could cause damage. To
wash the airplane, use the following procedure:
1.
Flush away loose dirt with water
2.
Apply cleaning solution with a soft cloth, a sponge or a soft bristle brush
3.
To remove exhaust stains, allow the solution to remain on the surface longer
4.
To remove stubborn oil and grease, or any accumulation of carbon wipe the area with a rag
dipped in lead free gasoline.
5.
Rinse all surfaces thoroughly
6.
Any good automotive wax may be used to preserve painted surfaces. Soft cleaning cloths or
a chamois should be used to prevent scratches when cleaning or polishing. A heavier
coating of wax on the leading surfaces will reduce the abrasion problems in these areas.
7.10.2 Windshield and Windows
1.
Remove dirt, mud and other loose particles from exterior surfaces with clean water
