Bush WO377, Instruction Manual

Page: 13 / 23

Using your DAB Alarm Clock Radio
Let’s get started
Using your DAB Alarm Clock Radio
Let’s get started
Using your DAB Alarm Clock Radio
Using your DAB Alarm Clock Radio> 24
25
section of these instructions, or online at www.bush-support.com If you still require further assistance, call one of our experts on 0345 600 3021.
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
There are 3 levels of compression:
• DRC off - no compression. This is the default setting.
• DRC low - medium compression.
• DRC high -
maximum compression.
Press and hold the Menu/Info button to enter the menu options.
1. Press and release the Tune- button to scroll to <DRC> . Press and release the Select
button.
Note: the current DRC setting will have an ‘ * ’ in the display.
2. Press and release the Tune+ button to scroll through the options and press and release
the Select button to confirm.
FM Radio mode
• If you are not already in FM mode, press and release the Power/Mode button to go to
FM mode (check the display).
• If you were listening to an FM station when you switched the Radio off then this
station will be automatically selected when you switch the Radio back on.
Telescopic aerial
Please make sure that the aerial is fully extended before you attempt to tune to a FM
station (a vertical position is recommended). This will ensure that the maximum signal
strength is available when the radio begins to scan. Extending the aerial also ensures the
best possible sound quality.
Tuning to an FM station
• Press and hold the Tune+ button to scan up the frequency band.
• Press and hold the Tune- button to scan down the frequency band.
• Press and release the Tune- or Tune+ button to fine tune each frequency in 0.05MHz
steps.
Note: If reception is still poor try moving the radio to another location.
Changing the Scan setting
In FM mode:
1.
Press and hold the Menu/Info button to enter the menu options.
2. Press and release the Tune+ button until FM <Scan setting> is displayed. Press and
release the Select button. The current Scan setting will have an ‘*’ in the display.
There are two different options to choose from:
• Strong stations - The scan will only stop when a strong signal strength is received
which should also result in a better audio quality. It is possible that the station you are
scanning for may be missed using this option.
• All stations - The scan will stop for every station it receives, even if the signal strength
is poor.
3.
Press and release the Tune+ button to choose from the two options available and
press and release the Select button to confirm.
Audio mode
The radio will automatically switch between Stereo and Mono, depending on the quality
of the signal being received but you can override this function and manually switch
between Stereo and Mono.
1. Press and hold the Menu/Info button to enter the menu options.
2.
Press and release the Tune- button to scroll to
<Audio setting>
. Press and release the
Select button.
There are now two different options of <Forced mono> and <Stereo allowed> and
the current setting will have an ‘*’ display.
3. Press and release the Tune+ button to choose from the two options available. Press
and release the Select button to confirm.