SETTING THE CLOCK
The clock in this radio is equipped to receive a DAB radio frequency time
signal. After the unit has been turned on, it will automatically tune into a
DAB radio station and update the clock. It may be necessary to wait for 1-2
minutes to allow the unit to receive the time signal. If the area will only
receive an FM signal it will be necessary to manually set the clock. To
manually set the clock
Set the clock in STANDBY mode
1. Insert the adaptor cord into the power socket at the rear of the radio.
Plug the adaptor into the mains supply socket.
2. The display backlight will illuminate for a few seconds, a welcome
message (F1) will appear in the display briefly and the clock will be
displayed “00:00:00 Time is not set” will be displayed
3. In standby mode, press the
ALARM
button, the hour digits will flash in
the display, press
TUN/CH
▼
/
▲
buttons to set the correct hour, then
press the
SELECT
button to confirm.
4. The minute digits will now flash, press
TUN/CH
▼
/
▲
buttons to set the
correct minute.
5. Later you will enter to “Set date 1-1-2014”. Press
TUN/CH
▼
/
▲
buttons
to set date and press
SELECT
button to confirm again.
Set the clock in working mode
1. Connect the radio to AC mains (via AC/DC adaptor), then press
STANDBY
to turn the radio on.
2. Press and hold
MENU
button, and then press
TUN/CH
▼
/
▲
buttons
until the display show “System”. And press the
SELECT
button confirm.
3. Continue press
TUN/CH
▼
/
▲
buttons until the display shows “Time’
and then press the
SELECT
button to confirm. The display will show
“<Set Time/Date>”, press the
SELECT
button to confirm again.
4. The hour digits will flash in the display, press
TUN/CH
▼
/
▲
buttons to
set the correct hour, and then press the
SELECT
button to confirm.
5. The minute digits will now flash, press
TUN/CH
▼
/
▲
buttons to set the
correct minute.
6. Later you will enter to “set date 1-1-2014”, press
TUN/CH
▼
/
▲
buttons
to set date and press
SELECT
button to confirm again.
7
Summary of Contents for NE-6005
Page 1: ......
