F.7
Press
TUN/CH
▼
/
▲
buttons to select “Stereo allowed/Forced mono” and
then press the
SELECT
button to confirm the setting.
Note:
The radio will automatically switch between stereo and mono mode,
but you can override this and switch this function manually which is helpful
for poor signal reception.
FM display modes
Every time you press the
INFO
button, the display will cycle through the
following display modes: RDS Radio Text, Programme Type, Frequency,
Mono/Stereo, Power status (Mains/Battery), Time and Date.
STORING AND RECALLING STORED STATIONS
This function allows up to 10 stations to be programmed into the memory
and stored in both DAB and FM mode.
1. To store a preset, first tune to your desired station, then press and hold
the
PRESET
button for longer than 2 seconds ,the display will show
“Preset Store <#:(Empty)>” (F.7).
2. Press
TUN/CH
▼
/
▲
buttons to select your desired station preset number.
3. Press the
SELECT
to confirm your selection, the station now
broadcasting has now been stored in the selected location (F.8).
4. To listen to the preset stations, press the
PRESET
button once and
then press
TUN/CH
▼
/
▲
buttons to select the desired preset location.
And press the
SELECT
button to confirm. (F.9) The station name or
frequency and preset location number will be displayed in the lower half
of the display.
If the preset has not been allocated, “Preset Recall <#: (Empty)>” will
be shown in the display.
Preset Store
< 1 : Empty >
F.8
Preset 1
Sto red
F.9
Preset Recall
< 6 : BBC Radio 6 >
F.10
Alarm 1 Setup
SETTING ALARMS (AC OPERATION ONLY)
1. Alarms can be switched on or off in standby
mode . However, the alarm parameters can
only be set when the product is on.
10
Summary of Contents for NE-6005
Page 1: ......
