Bush BFSSAE12B, Instruction Manual

Page: 17 / 39

Installing your Dishwasher
Bringing it all together
17
3.4 Water drain hose
Connect water drain hose directly to water drain hole
or to the sink outlet spigot. This connection should be
minimum 50 cm and maximum 110 cm from floor
plane.
IMPORTANT: Items will not wash properly if a
drain hose longer than 4 m is used.
3.5 Electrical Connection
WARNING: Your machine is set to operate
at 220-240 V. If the mains voltage supply to your
machine is 110 V, connect a transformer of 110/220
V and 3000 W between the electrical connection.
Connect the product to agrounded outlet
protected by a fuse complying with the values in
the "Technical Specifications" table".
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
CAUTION:
TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER
(OR BACK). NO USER-SERVICEABLE
PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
CAUTION:
TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER
(OR BACK). NO USER-SERVICEABLE
PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
e any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions, ou requir If y
or online at
www.bush-support.com
If you still require further assistance, call one of our experts on
0345 257 7271
.
Installing your Dishwasher
The earthed plug of the machine must be
connected to an earthed outlet supplied by
suitable voltage and current.
In the absence of earthing installation, an
authorised electrician should carry out an earthing
installation. In the case of use without earthing
installed, we will not be responsible for any loss of
use that may occur.
The plug on this appliance may
incorporate 13A fuse depending on the target
country. (For Example UK, Saudi Arabia)
3.6. Fitting the machine undercounter
If you wish to fit your machine undercounter, there
must be sufficient space to do so and the
wiring-plumbing must be suitable to do so (1). If the
space under the countertop is suitable for fitting your
machine, remove the worktop as shown in the
illustration (2).
WARNING: The countertop, of which the machine
will be placed under, must be stable in order to prevent
imbalance.
The top panel of the dishwasher must
be removed to fit the machine under the countertop.
To remove the top panel, remove the screws that hold
it on, located at the rear of the machine. Then, push the
panel 1 cm from the front towards the rear and lift it.
Adjust the machine feet according to the slope of the
floor (3).
Fit your machine by pushing it under the counter taking
care not to crush or bend the hoses (4).
WARNING: After removing the top panel of your
dishwasher, the machine should be placed in a space
of the dimensions shown in the figure below.
H1: min A
H2: min B1
H3: min B2
A B
All
Products
B
1
B
2
Product’s Height
(±2 mm) 820 mm 830 mm 835 mm
A: If there is no felt on the top of the
product; you should take into account this product’s height.
B1: If there is felt on the top of the product with 2nd basket; you
should take into account this product’s height.
B2: If there is felt on the top of the product with 3rd basket; you
should take into account this product’s height.