Bush 135873546, Instruction Manual

Page: 19 / 35

19
Using your DAB/FM Radio
Let’s get started
3. The display will now show ‘Factory Reset? <No> Yes’ (fig. 8). Use the
SCROLL knob until <Yes> is shown and then press the SELECT button
to confirm. The radio will display ‘Restarting….’ and will then go into
standby mode.
4. Proceed as per section 6.1 to re-start the unit and scan for stations.
Note:
All stored programmed stations will be lost during reset.
USING THE RADIO - FM MODE
FM MODE - TUNING
1. To select FM radio, press the MODE button, until the display shows ‘FM’ and then the frequency.
2. To activate auto search turn and hold the SCROLL knob until and the
radio starts to scan the frequency band, the display will show ‘Scanning
… ‘(fig.9), and it will stop automatically once a station has been found.
If the SCROLL knob is turned anticlockwise the frequency will search
down the frequency and if turned in a clockwise direction it will
search upwards.
3. To search manually, turn the SCROLL knob and immediately release to increment the
frequency up or down by 0.05MHz.
4. To change the audio mode (stereo or mono), press and hold the MENU / INFO button and turn
the SCROLL knob until ‘Audio setting’ is displayed. Press the SELECT button to accept. Use the
SCROLL knob to switch from ‘Stereo allowed’ to ‘Forced mono’ and press again to switch back.
If ‘stereo allowed’ is selected the radio will automatically switch between stereo and mono
mode. Once the audio mode of choice is displayed, press the SELECT button to accept.
5. To set the scan criteria, press and hold the MENU / INFO button and turn the SCROLL knob
until ‘Scan setting’ is displayed. Press the SELECT button to accept. Use the SCROLL knob
to switch from ‘All stations’ to ‘Strong stations’ and again to switch back. If ‘strong stations’
is selected the radio will only scan for strong stations. Once the scan criteria of choice is
displayed press the SELECT button to accept.
6. If an FM RDS (Radio Data Signal) is present, the display will automatically show the station name
and radio text (if available).
FM DISPLAY MODES
This function allows information relating to the current station to be shown in the second line of
the display.
If the INFO button is then pressed repeatedly, the second line of the station display will scroll
through the following modes with each subsequent press of the button (fig.10).
fig.8
fig.9
Time Date
Audio mode
Radio text Programme type
frequency Power
fig.10