Bush 135873546, Instruction Manual

Page: 15 / 35

15
Using your DAB/FM Radio
Let’s get started
SETTING THE CLOCK
The clock in this radio is equipped to receive a DAB and FM radio frequency time signal.
1. Place the appliance on a flat and stable surface.
2. Connect the adaptor lead into the socket at the rear of the radio, plug in and switch on at the
mains. The display backlight will illuminate for a few seconds, a welcome message (fig.1) will
appear in the display briefly, the clock (00:00) will then flash in the display and a message ‘time
is not set’ will appear underneath.
3. If a signal can be received in the area of operation after a short time the clock will automatically
synchronise to the local time and then the unit will enter standby mode.
4. If the clock does not automatically set, the clock can be set manually see section 7.6 and 8.3 .
Note:
Each of the above steps need to be completed within 10 seconds of pressing the button, otherwise
the screen will clear.
BASIC OPERATION - GETTING STARTED
1. Place the appliance on a flat and stable surface.
2. Connect the mains lead into the socket at the rear of the radio, plug
in and switch on at the mains. The display backlight will illuminate for
a few seconds, a welcome message (fig.1) will appear in the display
briefly, the clock (00:00) will flash in the display.
3. Fully extend the telescopic antenna.
4. Press the STANDBY(
) button to turn the unit on, the DAB mode will
automatically be selected and the radio will perform a full autoscan.
The display will show ‘Scanning’, together with a slide bar (fig.2) that
indicates the progress of the scan and the number of stations found
so far.
5. Once the scan has finished, the radio will select the first
alphanumerically found station.
6. Adjust the volume to the desired level by turning the VOLUME knob. Turn anticlockwise to
reduce the volume and clockwise to increase the volume.
7. Turn the SCROLL knob to scroll through the located stations. Once the station of choice is
located, press the SELECT button to select the station.
8. Move the antenna or radio until the best reception is received.
9. To switch to FM radio, press the MODE button. Press the button again to return to DAB.
10. To switch the radio into standby mode, press the STANDBY (
) button. The radio will silence,
the display will dim but the clock will still be displayed.
11. To turn off the radio, unplug from the mains supply.
fig.1
fig.2