Bush Hog XLRR1022-I, Operator'S Manual, Page: 40 / 82

ASSEMBLY
XLRR-I 05/21 Assembly Section 3-10
© 2021 Alamo Group Inc.
A
SS
EM
B
LY
OPTIONAL CENTER RAKE WHEEL KIT (3690405)
To assemble the Center Rake Wheel Kit proceed as follows:
Remove the four central screws that connect the horizontal drawbar to the main frame and attach plate (1)
using 4 long screws (15) that are supplied and nuts (16). Assemble arm (2) and hydraulic cylinder (4) to plate
(1) using the two arm support pins (8), washers (10) and spring pins (11). Connect the arm and cylinder with
the milled pin (9), washer (10) and spring pins (11). Attach the spring (5) first with hook in the hole in plate (1)
and screw (6) in hole in pin (9). Tighten nuts (12) on screw, letting a few millimeters (1/8”) protrude. The spring
tension must be adjusted later according to the desired pressure of the rake wheel on the ground. Attach rake
wheel (3) to the arm (2) using screws (13), washers (14) and nuts (12).
Assembly must be done carefully and accurately, for the safety of the person(s) doing the
assembling and to ensure proper machine operation. Assembly should be done on a flat,
solid surface, using the proper tools and wearing suitable clothing, making sure that all
people not involved in the assembly to kept at a safe distance. Assemblers must provide
suitable lifting mechanisms and supports for stabilizing the partially assembled units, so as
to prevent them from falling and causing damage or injury.