OPERATION
MPG PLUGGER 09/20
Operation Section 4-4
O
PE
R
AT
IO
N
© 2020 Alamo Group Inc.
2. TRACTOR REQUIREMENTS
Operating the plugger with a tractor that does not meet the following requirements may cause tractor or
implement damage and be a potential danger to the operator and passersby.
Tractor Requirements and Capabilities
•
ASABE approved Roll-Over Protective Structure (ROPS) or ROPS cab and seat belt.
•
Tractor Safety Devices ....................Slow Moving Vehicle (SMV) emblem, lighting, PTO master shield
•
Tractor Horsepower ......................... Max 60 PTO HP
•
Front End Weights............................ As need to maintain 20% weight on front axle
2.2 Tractor Horsepower
The power required to operate this implement is determined by the tractor PTO horsepower. For most
operating conditions, the plugger require a tractor with the maximum of 60 PTO HP. Operating these
implements with a tractor that does not have adequate power may damage the tractor engine. Exceeding the
recommended horsepower may cause plugger damage by overpowering the unit in heavy operating
conditions.
2.1 ROPS and Seat Belt
The tractor must be equipped with a Roll-Over-Protective-Structure (ROPS) (tractor cab or roll-bar) and seat
belt to protect the operator from falling off the tractor, especially during a roll over where the driver could be
crushed and killed. Only operate the tractor with the ROPS in the raised position and seat belt fastened.
Tractor models not equipped with a ROPS and seat belt should have these life saving features installed by an
authorized dealer.
OPS-U- 0003
Operate this Equipment only with a Tractor equipped with an approved roll-
over-protective system (ROPS). Always wear seat belts. Serious injury or even
death could result from falling off the tractor, particularly during a turnover when
the operator could be pinned under the ROPS.
(SG-7)
2.3 Front End Weight
A minimum of 20% total tractor weight must be maintained on the tractor front end at all times. Front end
weight is critical to maintain steering control and to prevent the tractor from rearing up while driving. If the
front end is too light, add weight until a minimum of 20% total weight is reached on the front tires. Front
weights and weight carriers can be purchased through an authorized tractor dealership.
OPS-U- 0005
3. GETTING ON AND OFF THE TRACTOR
Before getting onto the tractor, the operator must read and completely understand the implement and tractor
operator manuals. If any part of either manual is not completely understood, consult an authorized dealer for
a complete explanation.
OPS-U- 0007
Summary of Contents for TOUGH MPG-600
