Bush Hog 2310 Series, Operator'S Manual

Page: 101 / 204

ASSEMBLY
2310 SERIES 09/20 Assembly Section 3-5
© 2020 Alamo Group Inc.
ASSEMBL
Y
3 POINT LIFT MODEL ASSEMBLY
SEMI MOUNT MODEL ASSEMBLY
1. Remove the mast from the shipping position and attach the LH and RH Mast to the inside of the inner
mount plates using the rear holes. Install the 2 Strut Bushings in the holes of the Mast. Install using the
5/8” x 2” capscrew, 5/8 SAE flatwasher and 5/8” locknut. Make sure the 5/8” flatwasher is installed to
the inside against the bushing in order to retain it in the mast.
2. Assemble the mast halves by placing the CAT I Quick Hitch Top Bushing between the mast in the lower
hole and install the 3/4” x 4” capscrew and 3/4” locknut.
3. Attach the RH and LH pivot arm halves to the top holes on the mast. Place the mast spacer between
the mast and the pivot arms halves to the outside of the mast. Place a spacer bushing in each pivot
arm and install a 3/4” x 5-1/2” Capscrew and 3/4” Locknut.
4. Install the Driveline Holder to the right hand inside strut using the hole the shipping stand was bolted to.
Use the 1” x 2-1/2” capscrew, 1” lockwasher and 1” hex nut to attach the Driveline Holder.
1. Semi Mount Models do not require the Mast or Struts and Flex Links used on the 3 Point Lift models.
2. Cat.II Hitch Pins with Cat. III Bushings and Spacer Bushings are shipped installed to the lift points
of the cutter.
3. Install the Driveline Holder to the right hand inside strut using the hole the shipping stand was bolted to.
Use the 1” x 2-1/2” capscrew, 1” lockwasher and 1” hex nut to attach the Driveline Holder.
RH Mast
LH Mast
Strut
Bushing
Spacer
Bushing
Spacer
Bushing
5/8” SAE
Flatwasher
5/8” SAE
Locknut
5/8” x 2”
Capscrew
1” x 2-1/2”
Capscrew
1” Lockwasher
1” Hex Nut
Drivline Holder
3/4” x 4”
Capscrew
3/4” x 5-1/2”
Capscrew
Cat I QH Top
Bushing
3/4” Locknut
3/4” Locknut
Mast Spacer
Cat. I Hitch Pin
3 Point Lift and
Semi Mount
Cat. II Bushing
3 Point Lift and
Semi Mount Spacer Bushing
3 Point Lift and
Semi Mount