BUSCH Mink Oxygen, Instruction Manual

Page: 18 / 24

11 | Troubleshooting
18 / 24 0870168409_MV0602B_O2_A0000_IM_en_MD
SCH
Mink
B
U
CPL
IS
VRE
Problem Possible Cause Remedy
The machine does not start. The motor is not supplied
with the correct voltage.
• Check the power supply.
The motor is defective. • Replace the motor.
The coupling (CPL) is de-
fective. • Replace the coupling
(CPL).
The machine does not
reach the usual pressure on
the suction connection. The inlet screen (IS) is par-
tially clogged. • Clean the inlet screen
(IS).
The vacuum relief valve
(VRE) is misadjusted or de-
fective. • Replace the vacuum re-
lief valve (VRE)
The inlet filter cartridge (op-
tional) is partially clogged. • Replace the inlet filter
cartridge.
Internal parts are worn or
damaged. • Repair the machine (con-
tact Busch).
The machine runs very
noisily. Worn coupling (CPL). • Replace the coupling
(CPL).
Oil level too low. • Top up oil.
Defective bearings. • Repair the machine (con-
tact Busch).
The machine runs too hot. Insufficient cooling. • Remove dust and dirt
from the machine.
Ambient temperature too
high. • Observe the permitted
ambient temperature,
see
Technical Data
[ ► 19] .
Temperature of the process
gases at the inlet too high. • Observe the permitted
gas inlet temperature,
see
Technical Data
[ ► 19] .
Oil level too low. • Top up oil.
For the solution of problems not mentioned in the troubleshooting chart contact your
Busch representative.