Device Functions
System Manual 2CKA001473B9426
│17
Trimmer setting blockage
– The setting of the device can be blocked by the trimmer through the app. Three setting
variants are possible:
■
Trimmer blocked:
The values can be set only using the app.
■
Limited access:
Activation takes place via the app. After that, the password can no longer by bypassed
by the disconnection of the presence detector. Reactivation is possible only through the
following trimmer setting:
– In the first 2 minutes after activation,
set the trimmer for the brightness-
value threshold to "Sun" and the
trimmer for the operation mode to
"Automatic with 30-minute switch-off
delay".
Within these first 2 minutes, the app
can access the presence detector
without a password.
min
HA
1
5
A
30
min
15
30
15
5
1
time
T
5
Lux
50
300
1.000
2.000
■
Trimmer active:
The settings can be made through the trimmer and app. In general, the last setting
(trimmer or app) is always used.
– Password forgotten/reset password:
– If the device password is no longer known, it can be reset using the "Reset to factory
setting" app function. No device password is set in the factory setting.
ATTENTION!
All individual device settings and saved "Energy Monitor" data are also lost.
Presence simulation
– The user can activate a "Presence Simulation" in the app. The presence simulation runs
when the user is on holiday, for example. During this time, the light goes on and off as if
someone were home.
– There are 3 time ranges:
■
In the evening (starting time up to 11:00 pm)
■
At night (11:00 pm to 6:00 am)
■
In the morning (6:00 am to the set ending time)
– During the three time ranges the lights switch according to normal presence. In the
evening the lights switch off three times at random. During the night the lights switch on
three times at random. In the morning the lights switch on brightness dependent.
