Device Functions
System Manual 2CKA001473B9426
│15
3.2
Functions
Automatic/semi-automatic
■
Automatic operation mode (A)
– The light switches on fully automatically due to detected movements in the surveillance
area. The brightness threshold must be below the set value.
– The light is switched off after leaving the room plus a set switch-off delay or when the
set brightness threshold is exceeded.
■
Semi-automatic operation mode (HA)
– An extension unit operation is necessary to switch the light on, e.g. via a push-button.
The behaviour is then the same as fully automatic.
– The light is switched off after leaving the room plus a set switch-off delay or when the
set brightness threshold is exceeded.
■
Short-time pulse operation mode ( )
– In this operating mode short-time pulses are sent for the duration of detection (1 second
ON/9 seconds OFF). The short-time pulse serves for activating staircase light switches
or door bells, for example. The subsequent behaviour depends on the activated device.
In the case of DALI devices, the short-time pulse cannot be activated.
Comfort automatic
– An extension unit operation is necessary to switch the light on when entering a room, e.g.
via a push-button. The behaviour is then the same as fully automatic.
– If the brightness drops below the brightness-value threshold when there is presence in a
room, the light is switched on automatically. In semi-automatic mode an extension unit
operation would in this case be necessary, e.g. via a push-button.
– The light is switched off after a person leaves the room plus a set switch-off delay or when
the set brightness threshold is exceeded.
Soft phase-in/soft phase-out
– A switch-on and switch-off of lights via a dimming function. The times for the dimming
function cycle can be set by the app depending on the device.
Daylight-dependent control (constant light control)
– The brightness of the light in a room is optimised to the respective use. The normal
brightness fluctuations, e.g. due to the sunlight entering the room depending on the time of
day, are compensated as far as this is possible via the lighting and the spatial conditions.
The set value for room brightness can be set using a potentiometer on the device or by app.
