15
Glass
Outlet Grille
Combustion
Air inlets
how to adjust the thermostat for desired comfort levels.
The user shall also be made aware of the precautions to prevent blockage of any purpose made
room ventilation, and the need to keep soft furnishings away from the appliance.
The outlet grille and glass on the appliance are working surfaces. On no account should these be
covered or obstructed. The air inlets should also be kept clear.
The user shall be made aware of the need to operate the appliance safely in accordance with
sections 8-12 of the instructions and of the need for regular servicing and maintenance (section
13).
The user shall be informed of the need for at least an annual service and the importance of
returning the guarantee card.
The installer section of the guarantee card must be filled in fully to
validate the warranty.
Advise that a fireguard to BS6539 or BS6778 should be used for the protection of the elderly, the
infirm or children.
13.0 Maintenance and Servicing
13.1
Any maintenance and servicing shall be carried out at least on an annual basis and by a
competent person in accordance with relevant regulations.
13.2
Before carrying out any servicing procedure ensure the gas supply to the appliance is
isolated and that the appliance is cold.
13.3
After completion of any servicing procedure check for gas soundness.
13.4
Check the installation for compliance with these instructions.
13.5
Check all purpose provided ventilation is clear from obstruction.
13.6
The following servicing procedure is recommended in order to cover all aspects of the
appliance to ensure safe and correct operation of the appliance:
Protect the floor area around the appliance to avoid damage or soiling when laying out the
component parts.
Open the decorative trim frame; unscrew the fixing screws holding backer to fire, lift backer off
and place to one side
.
The trim may be cleaned with a damp cloth.
Remove the outlet grille by removing the 3 screws in its underside. Clear away any dust or debris
from the openings using a soft brush and vacuum, and place to one side.
Remove the 3 screws in the catalyst vent panel (Fig. 3) and remove the glass panel by lifting the
vent panel slightly and withdrawing the glass from the lower location point. The glass panel can be
cleaned using hot water and a mild non - abrasive detergent. Check the glass for damage and
replace in if
necessary.
